While your pressure washer has been produced
with quality materials and craftsmanship, you as the
owner have certain responsibilities for the correct
care of the equipment. Attention to regular
preventative maintenance procedures will assist in
preserving the performance of your equipment.
Contact your Hydro Tek dealer for maintenance. A
small investment in preventative maintenance will
add many hours to the life of your pressure washer.
Perform maintenance more often under severe
conditions. Do not spray high-pressure water onto
the machine. Not all maintenance items apply to
all machines.
MAINTENANCE SCHEDULE**
After first 8 hours then every 50 hours especially in high ambient temperatures
Check daily (maximum 50% antifreeze)
Check monthly 12V DC Burner Systems: Replace battery every 2 years
After first 25 hours, then every 6 months or 500 hours
Axial pumps come filled with synthetic oil, which does not require changing
Clean/Replace Burner Filter
Monthly (More often if fuel quality is poor)
Burner Adjustment/Cleaning
Annually (More often if required)
Clean Water Screen/Filter
Monthly (Check tires for condition, tighten lug nuts, grease & check bearings)
Cat Hydraulic, non-detergent 10w 40 ISO 68
General, non-detergent SAE 30w
** Check the engine manufacturer’s service guide for additional maintenance items and specific high ambient
temperature oil selection.
MAINTENANCE INFORMATION 18
To Previous Page
Loading...