extensions generally come in 50’ and 100’ lengths.
Specify maximum pressure and temperature of
your machine when ordering.
Low-pressure inlet garden hoses are available in
50’ and 100’ lengths. Premium quality, 200psi
rated hoses are recommended.
HOSE REELS: Hose
reels are available for
convenient and quick
storage of both discharge
and inlet hoses.
Different hose reels
options are available for
trailer mounting, machine
mounting, or as base
mount options. To keep the hose from unreeling,
lock the drum in place and secure the gun or the
end of the hose or it may drag on the road. The
low-pressure hose should be of sufficient quality
that it will not flatten out when reeled up, or water
supply to the machine will be cut off.
If the reel swivel begins to leak, replace or connect
the hose directly to the machine until the leak is
repaired. Hose reel swivels with lubrication are
pre-lubricated at the factory. Additional lubrication
intervals depend on application and frequency of
use. However, a minimum for re-lubrication at 40
hours is recommended. Standard Moly-Lith grease
is recommended. Do not over grease. Using a
hand held grease gun, dispense one pump of
grease into the grease fitting. Depress the ball
bearing at the end of the grease fitting to allow the
grease and air to escape. WARNING: Replace
discharge hose with original equipment hose rated
for 250°F, available at Hydro Tek dealers.
HYDRO TWISTER – Surface Cleaners:
The Hydro Twister® is a
flat surface cleaner that
connects to a pressure
washer and uses a spray
bar rotating at a high
speed within 1” of the
ground. It will clean
concrete more consistent
than an operator with a
spray wand, with less
fatigue, and 10-20 times
faster. Simply move the
twister over the surface
and watch a clean path
appear behind the unit.
The Hydro Twister can be used with hot water up to
250º on most models for extra stubborn grease or
grime, eliminated the need for soap pretreatment in
most applications. Rated to be used with a
pressure washer up to 4000psi and up to 10gpm.
See your dealer for proper nozzle size
configurations to match your pressure washer.
Available models are: ANT19, ANT20, ANT28,
ANT38, and the Contractor Series ANT3C.
Twisters with vacuum recovery capability are also
available ANTV3 and ANT12
WASTEWATER CONTAINMENT AND
RECOVERY: Hydro Tek manufactures Hydro
Vacuum®, a product line of mobile wastewater
recovery accessories. Starting with containment
berms to divert
wash water away
from storm drains
and toward a
vacuum pickup
device. The
vacuum system
can be used to
simply pickup and transfer the water to a bulk tank
or filter the water for washing reuse or sanitary
sewer disposal.
Vacuum system choices are either fully portable
(on wheels) or truck or trailer mount systems.
Dispose of collected wastewater properly: Permits
can be obtained to dump wastewater into a sanitary
sewer system if properly treated and tested. It is
illegal to allow wash water to run into storm drains.
To Next Page
Loading...