Hydrofarm Autopilot APC8200 User Manual

SPECIFICATIONS
Typical test condions, unless otherwise specied: Ambient Temp =73+/-3°F, RH=50%-70%,
Altude=0~100 meter
DISCLAIMERS
This device is not intended for workplace hazard CO
2
monitoring, nor intended as a denive monitor
for human or animal health instuons, life sustenance, or any medical-related situaon.
Hydrofarm and the manufacturer assume no responsibility for any damage or loss suered by the user
or any third party arising through the use of this product or its malfuncon.
Hydrofarm reserves the right to change the specicaons without noce.
MEASUREMENT SPECIFICATION
Operang Temperature 32°F to 122°F (0°C to 50°C)
Storage Temperature -4°F to 140°F (-20°C to 60°C)
Operang & Storage RH 0-95%, non-condensing
CO
2
Measurement
Accuracy at 0~3000 ppm ±50 ppm or ±5% of reading, whichever is greater
Accuracy over 3000 ppm ±7%
Repeatability 20 ppm at 400 ppm (standard dev. of 10 readings in 1 minute)
Measurement Range 0-5000 ppm
Display Resoluon 1 ppm (0-1000); 5 ppm (1000-2000); 10 ppm (>2000)
Temp Dependence
±0.2% of reading per °C or ±2ppm per °C, whichever is greater,
referenced to 25°C
Pressure Dependence 0.13% of reading per mmHg (corrected by user’s altude input)
Response Time <2 min for 63% of step change or <4.6 min for 90% step change
Warm-up Time <30 sec
Power input AC 100 ~ 240 VAC
Dimension
Sensor Unit: 153x33x27mm (6.0"x1.3"x1.1")
Control Unit: 195x145x44mm (7.7"x5.7"x1.7")
Weight 700 g (24.7 oz)
6

Hydrofarm Autopilot APC8200 Specifications

General

Brand	Hydrofarm
Model	Autopilot APC8200
Category	Controller
Language	English