Hydrofarm.com
8
CABLE GUIDE
Advanced Digital & Analog
Lighting Controller
(APDPX2)
Fixtures are not shown to scale.
IMPORTANT: Do not attach data link cables to AC power cable. Always keep low voltage data cables and high
voltage AC power harness as far as possible from each other for stable signal transmission. Avoid coiling data as
well as AC harnesses in circles. Excess cable should be managed by creating long loops as opposed to tight coils.
• For use with PHOTOBIO X, M, T, and T Duo
• Includes 2 cables and 1 T Connector
PHOTO•LOC Cable
CHC882000B
Female end
Male end
T Connector
LEGEND: LED Fixtures
ZONE A
Controls up to
50 LED fixtures.
ZONE B
Controls up to
50 LED fixtures.
1 Attach ORANGE end of cable
to the black side of the
T connector.
2 Attach BLACK end of cable
to the orange side of
T connector.
3 Attach BLACK end of cable
to the bottom orange side
of the T connector.
4 Attach ORANGE end of
cable to the black connector
on fixture.
PHOTO•LOC 0–10V Cable Kit
CHC882000B
PHOTOBIO
LED Fixtures
IMPORTANT: Do not attach data link cables to AC power cable. Always keep low voltage data cables and high voltage AC
power harness as far as possible from each other for stable signal transmission. Avoid coiling data cables as well as AC
harnesses in tight coils. Excess cable should be managed by creating long loops as opposed to tight coils.
Note: Zone A and Zone B
can be set up in one room,
or in two separate rooms.
To Next Page
Loading...
