Hydrofarm Autopilot PX2 - Analog;Digital Configuration; Analog Setup Mode; Digital Setup Mode; Mixed Analog;Digital Mode

Hydrofarm.com 4
ANALOG/DIGITAL SETUP
Before starng the display setup, you
must complete the Analog/Digital setup.
1. Using a pen or other small object,
press the recessed
SET buon
1
to
cycle through the following opons.
1
SYSTEM SETTINGS
The Systems Sengs screen is where the
controller’s overall seng are dened for
both zones.
1. Press
or to enter the
SYSTEM SETTING menu.
2. Press
to cursor through the
values and highlight the value you
want to change.
Value Opons
Temperature unit F or C
Power unit % or W
Hour format 12H or 24H mode
Time Hours/Minutes (AM/PM will adjust automacally)
Date Month/Day/Year
3. Press or to select the correct seng, then press to conrm.
4. Repeat steps 2–3 to set all values.
5. Press
to save the sengs.
ANALOG AND DIGITAL SETUP:
Zone A can support 50 LED xtures and
Zone B can support 256 HID xtures.
DIGITAL SETUP:
Each zone can support a maximum of 256 HID xtures.
ANALOG SETUP:
Each zone can support a maximum of 50 LED xtures.
INSTRUCTIONS