13
The following describes situations and possible solutions to common
problems may encounter as a spa owner. Note: your system may not
include all components listed.
Main Breaker is OFF - Set to On.
Sub-Panel Breaker Off - Set to On.
System GFCI Off - Set to On.
Power switch in Off position - Set to On.
Components not plugged in - Plug in components.
Power cord not plugged in - Plug in power cord.
Air Lock in Plumbing System - “Bleed” the system.
Restricted Flow - Insure that the water shut-off valves are open and that suction
fittings are not blocked by debris.
Low Water Level - Increase water level to recommended level.
Pump 1 Not Plugged-In - Plug in Pump 1.
Pump 1 Fuse Blown - Contact your local dealer.
Pump 2 Not Plugged-In - Plug in Pump 2.
Pump 2 Fuse Blown - Contact your local dealer.
Blower or Pump Not Plugged-In - Plug in the Blower or Pump.
Pump or Blower Fuse Blown - Contact you local dealer.
TROUBLESHOOTING
NOTHING OPERATES
NO, LOW or SURGING WATER FLOW
NO LOW SPEED OPERATION
NO JETS or BLOWER OPERATION
To Next Page
Loading...
