14
NO THERAPY JET OPERATION
Water Shut-Off Valves are Closed - Open Shut-Off valves.
Jets Not Properly Adjusted - Adjust Jets properly.
Diverter Valve Not Properly Adjusted - Adjust diverter valve properly.
Thermal Overload Tripping - Check for restricted flow of water.
Temperature Not Set Correctly - Adjust “Set Point” Temperature.
System Power Restriction - Depending on available power, the spa may have
interlocks in place to shut off the heater when the pumps are switched to high speed.
No Power - Reset breaker at service panel.
Low Water Flow - Clean or Replace filter.
Pressure Switch Not Adjusted Properly - Refer to “Pressure Switch Adjustment”.
Temperature Sensor Not in Dry-Well - Place sensor in dry-well.
Temperature Set Too High - Adjust “Set Point” Temperature.
High Ambient Temperature - Remove spa cover.
Light Bulb Defective - Replace bulb or contact your local dealer.
Reflector has Fallen Off - Replace deflector or contact your local dealer.
Light Not Plugged-In - Plug in the Light.
Spa Overfilled - Adjust water level.
Drain-Valve Left Open - Close drain valve.
Couplings or Unions Loose - Tighten or contact your local dealer.
Pump Seal Leaking - Contact your local dealer.
Plumbing / Connections Leaking - Contact your local dealer.
Water Leaking from Spaside Control - Contact your local dealer.
Water in Air Blower Plumbing - Contact your local dealer.
For correct GFCI breaker wiring, refer to page 5 for details.
NO LIGHT OPERATION
WATER LEAKS
NO HEAT
HIGH HEAT
GFCI TRIPS IMMEDIATELY
To Next Page
