Hydthc XPTHC-4 User Manual

地址：深圳市南山区中山园路
1001
Over
ARC-voltag
e range
The
actual arc voltage is over 30V
than
the
cutting
Collision
alarm
If the proximity switch is actived
before cutting or
means there’s collision, if over
0.2s will have the E5 alarm.
Meanwhile send out the collision
signal to CNC.
深圳市宏宇达数控技术有限公司
1001
号 E4-6C(TCL 国际 E 城) TEL：755-
26625800 FAX
-16-
actual arc voltage is over 30V
the
setting arc voltage during
cutting
1、 Setting
arc voltage is
2、 The
Dynastic pierce height is
high, please decrease
parameter value
3、
The auto signal is send from
THC too
early
4、
Plasma problem
consumable
5、
It’ll be solved after the arc voltage is
normal. It doesn’t affect the cutting,
but it’ll turn off the AUTO status.
If the proximity switch is actived
before cutting or
during cutting, it
means there’s collision, if over
0.2s will have the E5 alarm.
Meanwhile send out the collision
signal to CNC.
1、
Checking the Micro switch and its
connection;
2、
Proximity switch problem, change a
new one
3、
It must press the “MENU” button
to cancel the
are checked ok
深圳市宏宇达数控技术有限公司
26625800 FAX
：755-26729960
arc voltage is
too low
Dynastic pierce height is
too
high, please decrease
“P4”
parameter value
The auto signal is send from
CNC to
early
Plasma problem
, plasma
consumable
s etc.
It’ll be solved after the arc voltage is
normal. It doesn’t affect the cutting,
but it’ll turn off the AUTO status.
Checking the Micro switch and its
connection;
Proximity switch problem, change a
It must press the “MENU” button
to cancel the
“E5”alarm after all
are checked ok
.

Hydthc XPTHC-4 Specifications

General

Brand	Hydthc
Model	XPTHC-4
Category	Controller
Language	English