Page 6
1.4 Intended Use
HygroMatik electrode steam humidifiers
serve for steam production based on tap
water or partially softened water.
Only use supply water featuring a con-
ductivity of 125 to 1250 µS/cm.
D1: Lower threshold
C1: Range of reduced conductivity
(adjustment required)
A: Normal Tap water
B: Range of increased conductivity
C2: Range of high conductivity
(adjustment required)
D2: Upper threshold
In the C1 and C2 ranges, adaptation of the
periodic blow-down frequency may be
required. Pls. refer to the partial and full blow-
down parameter descriptions given in the
blow-down submenu chapter as well as in the
glossary.
Proper usage also comprises the adherence
to the conditions specified by HygroMatik for:
• installation
• dismantling
• reassembly
• commissioning
• operation
• maintenance
• disposal
Only qualified and authorised personnel may
operate the unit. Persons transporting or
working on the unit must have read and
understood the respective parts of this man-
ual, especially the „Safety Instructions“ given
in chapter 2. Additionally, operating person-
nel must be informed of any possible ha-
zards. A copy of the manual is to be stored at
the unit‘s operational location (or near the
unit).
By construction, HygroMatik steam humi-
difiers are not qualified for exterior appli-
cation.
Risk of scalding!
Steam with a temperature of up to 100 °C
(212 °F) is produced.
Do not inhalate steam directly!
:$51,1*
To Next Page
Loading...
