1. Electro Brush
2. Flexible Electro Hose EST with Remote Control Unit
3. Hard Electro Tube EST (2 pcs.)
HYLA EST VENTUS
ELECTRO BRUSH
SET
HYLA EST VENTUS ELECTRO BRUSH SET
Please always turn off the main switch of the HYLA
System before connecting or disconnecting the Electro
Brush. Before assembly, first ensure the Electro Brush is
set firmly on a flat surface and the swivel neck is locked
in an upright position. Assemble the Hard Electro Tubes
onto the Electro Brush. Insert the handle of the Flexible
Electro Hose into the Hard Electro Tube and connect
the Electro Flexible Hose to the Motor Unit. The main
switch will turn on the Electro Nozzle. To activate the
Electro Nozzle, release the Hard Electro Tube from its
parking upright locked position by pressing the button
located to the left of the swivel neck. You will see
a green light indicating operation. You can also use
the Remote Control Unit to switch on/off the Electro
Nozzle and the HYLA.
Maintenance:
• Disconnect power from the Electro Nozzle.
• Cut and vacuum textile fibres to remove from
the brush.
WARNING:
Never use the Electro Nozzle outdoors or on wet
surfaces. If the Electro Nozzle is overloaded, the built-in
protection will turn the Nozzle off and the red light
indicator may come on. Do not touch the brush roller!
Disconnect the power from the Electro Nozzle and clear
any objects blocking the roller. The Electro Nozzle will
operate when re-powered. Make sure body parts and
any loose clothing are well clear of rotating parts.
DEEP CLEANING
OF CARPETED
FLOORS
WITH HYLA ELECTRO NOZZLE
30 / 31
To Next Page
Loading...