1
2
BLOWING
• Remove exhaust grid on Motor Unit
Assembly.
• For full power while blowing, switch
on the HYLA, connect the Flexible Hose
to the front connector first and then
connect the hose to the exhaust.
1. Turn off the main switch and disconnect the
power cord from the power source.
2. Empty the Water Pan Assembly immediately after
use and rinse with clean water.
3. Wipe the underside of the Motor Unit Assembly
using a wet cloth. Do not rinse the Motor Unit
Assembly with water!
4. After use, the HYLA System should be stored
with the handle in the opposite position, to let
it dry.
WARNINGS
• Disconnect the power cord from the power
source before removing the motor unit
assembly from the Water Pan!
• DO NOT use the System without water!
• The HYLA EST Air and Room Cleaning System is
not designed for vacuuming larger quantities of
mineral dust!
• DO NOT vacuum flammable liquids!
AFTER
EACH USE
BLOWING / AFTER EACH USE34 / 35
To Next Page
Loading...