HYLA EST - WET CLEANING OF HARD FLOORS; WET CLEANING OF CARPETED FLOORS

• Connect the Hard Floor Nozzle to the Suction
Tube.
• Turn on the main switch and pull the valve
trigger to start the water flow.
• Clean the floor by moving the nozzle back and
forth with the suction device held at an angle
allowing for clearance of the squeegee strip
from floor.
• Release the valve trigger and dry the cleaned
floor by moving the nozzle backwards with the
suction device held at an angle allowing direct
contact of the squeegee strip with the floor.
• Use caution during wet cleaning not to exceed
the maximum level mark in the Water Pan.
WARNING! Wet floors may
be slippery!
WET CLEANING
OF HARD FLOORS
• Connect the Carpet Nozzle to the Suction
Tube.
• Turn on the main switch and pull the valve
trigger to start the water flow.
• Wash the carpet by moving the nozzle back
and forth with the suction device held at an
angle allowing clearance of front edge from
the carpet. Do not soak the carpet!
• Release the valve trigger and dry the cleaned
carpet by moving the nozzle backwards with
the suction device held at an angle allowing
direct contact of front edge with the carpet.
• Use caution during wet cleaning not to
exceed the maximum level mark in the Water
Pan.
WET CLEANING
OF CARPETED FLOORS
WET CLEANING OF HARD FLOORS / WET CLEANING OF CARPETED FLOORS 46 / 47