MX2800SE Quick Reference Guide
1 ATM Power On/Off
Open the upper front door. (①)
Press Power Switch (②) in the direction of “I”.
Press Power Switch (②) in the direction of “O”.
2
Open the Exterior door (①) using key.
Turn the safe door handle (③) and pull the door to
open.
E-lock Open (in case of Multiple-User Mode)
The factory default Master Code is 1 2 3 4 5 6. To open
the lock, enter 1 2 3 4 5 6 # then rotate the keypad to the
right if D•Drive or turn safe handle if any other model of
lock is installed.
<Note!>
The lock’s factory default code must be changed
to a unique. Refer to the operator manual for more.
3
The acceptable condition bills should be loaded
(Refer to Operator Manual)
Enter to Supervisor mode (Refer to
“8 OP Main Screen”)
Submit “TRIAL CASSETTE TOTAL” to
show note count.
* To show note count and to clear note
count, submit “CASSETTE TOTAL”
How to add note count,
- Select “SETTLEMENT” (①)
- Select “ADD CASH” (②)
- Select the cassette to be added the
notes (A) (③)
- Enter the note count and then press
ENTER
key in PIN Pad. (If you want to add
the cash for other cassette, repeat from “A”)
- After completing, press “APPLY” button (④
Pull out the cash cassette carefully.
Unlock the cassette cover using key (①).
Pull the push plate back until it is locked
against the push plate latch. (②) And then,
set the bills into the cash cassette.
Then, release the push plate from the cash
plate latch and allow it gradually to take up
its position behind the notes. (③)
Close the cassette cover with key, place
the cassette carefully on the set guide and push
it in the ATM until it is locked in place.
* The above description is based on 1000 new note
capacity cassette. For 2000 new note capacity
cassette, refer to operator manual.
1
2
3
1
2
1
2
3
4
2
1
3