Field Service Bulletin 1
HyPro2000 — HT2000 TORCH UPGRADE
Introduction
Purpose
This document describes the steps necessary to upgrade the HT2000 with the HyPro2000 torch.
Required tools
5/16 inch, 3/8 inch, 7/16 inch, 1/2 inch, open end wrench, and 2 inch spanner wrench.
Kits
Part number Description Qty
228549 Kit: HyPro2000 Torch retrofi t with Control PCB 1
228550 Kit: HyPro2000 Torch retrofi t 1
Torch retrofi t kit
HT2000 control PCB
DANGER
ELECTRIC SHOCK CAN KILL
Disconnect electrical power before performing any maintenance.
All work requiring removal of the power supply cover must be performed by a
qualified technician.
See the Safety Section of the system’s Manual for more safety precautions.
To Next Page
Loading...
