Field Service Bulletin 7
HyPro2000 — HT2000 TORCH UPGRADE
3. Label each connector before removing any connections to the old board. After labeling the connectors,
remove all connections to the control board. Any wires that are present but not connected to the board will
remain disconnected.
4. Remove the 6 screws that hold the control board in place, and remove the old control board. Save the screws
for reuse.
5. Install the new control board using the six screws from step 3.
6. Plug all the connectors into the appropriate receptacles on the new control board.
7. Replace the 2 front panels and continue to torch and quick-disconnect installation.
To Next Page
Loading...
