HyperX Cloud Buds - Headset Charging; Status LED Indicators; Factory Reset; Questions or Setup Issues

Document No. 480HX- HEBBXX.A01
HyperX Cloud Buds
Page 7 of 7
Headset Charging
When the headset is connected to a charger with the USB charge cable, the status LED will indicate
the charge status. The headset will take approximately 3 hours to fully charge.
Status LED
Charging Status
Breathing red
Charging
Off
Fully charged
Status LED Indicators
The status LED on the headset indicates the current state of the headset.
Status LED
Headset Status
Flash blue every 5 seconds
Connected to a device
Flash blue every 2 seconds
Not connected to a device
Pairing mode
Flashing red and blue
Factory reset
Flash blue 5 times and light up red for 1 second
Factory Reset
To perform a factory reset on the headset, hold the power and volume up buttons together for 7
seconds. The status LED will flash red and blue 2 times, followed by solid red for 1 second. At the
same time, the headset will play two low beeps. After this, the headset will automatically turn off.
Questions or Setup Issues?
Contact the HyperX support team at: hyperxgaming.com/support/headsets