Pairing and Connecting
The controller must be powered off before attempting to enter pairing mode.
2.4G
1. Set the mode selection switch to 2.4G.
2. Connect the 2.4GHz wireless adapter to the PC.
3. Tap the Home button. The controller will power on and attempt to connect to the
2.4GHz wireless adapter.
• If the controller has lost its pairing with the dongle, repeat steps 1-2 then
press and hold the Home button for 6 seconds until the LEDs animate to
indicate pairing mode.
• Bring the controller within range of the dongle to complete pairing.
Bluetooth
1. Set the mode selection switch to Bluetooth.
2. Press and hold the Home button for 6 seconds until the LEDs animate to indicate
pairing mode.
3. On your Bluetooth-enabled device, search and connect to “HyperX Clutch.”
USB
1. Set the mode selection switch to USB.
2. Plug in the USB-C cable into the controller.
3. Plug in the USB-A cable into your PC
4. Windows will recognize the controller as “HyperX Clutch”
To Next Page
Loading...
Need help?
General
