2200 SRM 1058 General
General
The information contained in this manual gives the
user a brief overview of the Electric Truck AC Con-
trols Program. This manual also explains the com-
mondrop-downmenufeaturesfortheuserthatare
listed under the File menu, the Reports menu, the
Tools menu, and the Help menu.
A personal computer (PC) can be used to set the trac-
tion motor and pump motor controller functions, read
status codes, and perform numerous diagnostic and
troubleshooting functions.
COMPUTER REQUIREMENTS
The PC must have the following minimum configu-
ration.
1. Either Microsoft
®
Windows 98™ or Microsoft
Windows 2000™ or later operating system must
be installed.
2. TheremustbeanopenUniversalSerialBus
(USB) port available on the computer to connect
to the lift truck.
3. There must be a compact disk read-only-memory
(CD-ROM) drive installed on the computer.
4. Microsoft Internet Explorer™ Version 5.01
or later must be installed on the computer.
5. The display screen resolution should be set to
800×600 pixels.
SOFTWARE, INSTALL
NOTE: See instructions included with CD and/or
readme.txt file on the CD for additional instruc-
tions and possible password requirements.
NOTE: When installing the software on a PC with
Microsoft Windows 2000, make sure that the
computer is setup with Administrator rights on
the computer.
NOTE: In the following examples, the D: drive repre-
sents the CD-ROM drive. The CD-ROM drive could
be a different letter on the computer.
To run the setup program, follow these steps:
1. Place the CD in the CD-ROM drive. Installation
will start automatically if the computer is set for
automatic start-up. If the computer is not set for
automatic start-up, go to Step 2.
2. Click Start.
3. Select Run and in the Open line enter
D:\setup.exe.
4. Click OK. The setup program will guide you
through the rest of the steps to install the Elec-
tric Truck AC Controls Program Hyster on the
computer.
It is recommended that the program is installed to
the default directories.
LANGUAGE SELECTION
1. Select the Language tab. SeeFigure1. Click
the drop-down list and select one of the following
languages:
•English
•German
•French
• Italian
•Spanish
2. When the desired language has been selected,
click OK to update the Options section. The
Electric Truck AC Controls Program Hyster text
will appear in the selected language.
1
To Next Page
Loading...
