To Next PageTo Next PageWhat to do if my HYT Two-Way Radio has no power?
If your HYT Two-Way Radio's battery is low, recharge or replace it. Also, ensure the battery is properly installed by removing it and re-attaching it.
How to block other voices on HYT Two-Way Radio?
If you're experiencing other voices (non-group members) on your HYT Two-Way Radio channel, change the CTCSS/DCS tone. Ensure all group members switch to the same tone.
Why does my HYT tc-600 battery drain fast?
If the power of your HYT Two-Way Radio doesn't last long even when fully charged, the battery may have lost its capacity. Replace it with a new one.
What to do if I can't hear my group on HYT Two-Way Radio?
If you can't talk to or hear group members on your HYT Two-Way Radio, make sure you are using the same frequency, CTCSS/DCS, and 2-Tone settings as your group. Also, your group members may be out of the communication range, so check their location.
General| Channel Capacity | 16 |
|---|---|
| Power Output | 5W |
| IP Rating | IP54 |
| Frequency Range | 400-470MHz |
| Operating Temperature | -20℃~+50℃ |
Specifies the VHF model of the TC-600 two-way radio covered in this manual.
Details compliance with national and international RF energy exposure standards and guidelines.
Provides guidelines for safe and efficient operation, including transmit/receive procedures.
Explains FCC compliance for the device and measures to correct interference.
Outlines FCC licensing requirements and dealer assistance for radio programming.
Lists important precautions for using and maintaining the radio, including safety warnings.
Provides instructions and notices for charging the radio's battery.
Step-by-step guide on how to attach the battery to the radio.
Step-by-step guide on how to remove the battery from the radio.
Instructions for attaching the radio's antenna.
Instructions for removing the radio's antenna.
Instructions for attaching the belt clip to the radio.
Instructions for removing the belt clip from the radio.
Guide for connecting an optional external earphone.
Covers fundamental operations like turning on, adjusting volume, and basic transmit/receive.
Explains the TOT feature used to prevent continuous transmission.
Details the TOT Reset Time feature for managing transmission limits.
Explains the TOT Rekey Time feature for resuming transmission after inhibition.
Describes the TOT Pre-Alert feature for warning before TOT expiration.
Information on the Battery Save feature to minimize power consumption.
Details the Low Battery Alert system for battery status.
Explains how to use the Monitor feature to check channel activity.
Describes the functionality and programming of the function key.
Details how to switch between high and low power transmission.
Explains dealer-configurable channel bandwidth options (wideband/narrowband).
Covers the 2-Tone signalling feature for selective calling.
Explains the DTMF ANI (Automatic Number Identification) feature.
Describes CTCSS/DCS signalling for filtering unwanted calls.
Explains the AND/OR logic for audio unmute conditions.
Details the Channel Scan feature for monitoring channels.
Explains setting and using a priority channel during scanning.
Describes the revert channel functionality during scanning.
Explains the Busy Channel Lockout feature to prevent talking on active channels.
