Instruction on RD98X Upgrade Firmware Upgrade Guide
16
z The prompt “The firmware version [xx.x.xx.xxx] is beyond the upgrade software!” indicates
the upgrade package is not compatible with the current firmware or model. Please stop
upgrading right away.
z “Reading data error!” or “Writing data error!” or alerts alike indicates the USB connection
has timed out. Click “OK”, and try the upgrade again by restarting the repeater and entering
the download mode.
z The prompt “Writing data error! RCDB data is already saved to file, from which you can
restore your data when necessary.” indicates the RCDB data error during upgrade. Click
“OK” and then you can see a “Restore” button in the main interface.
Step 6 (optional) Restore the repeater in case of the RCDB data abnormity, in this way:
1. Click “Restore” to proceed to the corresponding interface.
2. Select the serial number of the repeater to be restored, and click “Restore” again.
If the serial number is not available, do not click “Restore”.
3. Refer to Step 4 and Step 5 for further operation.
Step 7 A prompt box as shown below appears upon successful upgrade.
If no prompt appears, please try the upgrade again by restarting the repeater and entering the
download mode.
To Next Page
Loading...
