Supplementary Features User Manual
18
7.5.2 GPS Report
The GPS Report feature allows the radio to report its location information to the control center.
You can report the location information in either of the following ways:
Press the preprogrammed GPS Report key.
Request your dealer to configure the GPS Report trigger as power-on/off, preset time, or distance interval.
The radio automatically reports the location information according to the trigger.
7.6 BT
To derive optimal communication quality, it is recommended to use the BT devices approved by the
Company.
If BT earpieces of other companies are used, you must use them with the wireless ring PTT of the
Company. Otherwise, transmission is unavailable through the earpieces.
The BT feature allows the radio to connect to a BT device for short-distance communication and data exchange.
The BT feature applies only to radios with the BT module.
7.6.1 Enabling the BT Feature
You can enable the BT feature in either of the following ways:
Press the preprogrammed BT key.
After this feature is enabled, the LED indicator flashes blue every 3 seconds.
Request your dealer to enable the BT feature and the BT Always Discoverable feature.
After power-on, the radio automatically activates the BT feature and stays detectable for other BT devices.
7.6.2 Connecting a BT Device
Before connecting a BT device, check the connectivity between the radio and the BT device.
The connectivity is configured by your dealer through the CPS.
With the connectivity configured, the radio automatically searches and connects to the BT device.
After successful connection, the LED indicator of the radio flashes blue every 1.5 seconds.
To Next Page
Loading...
Need help?
General
