Owner’s Manual
Error! Use the Home tab to apply 标题 1,P
art,Document Header,Part1,Document Heade
r1,Part2,Document Header2,Part11,Document
Header11,Part12,Document Header12,Part2
1,Document Header21,Part111,Document He
ader111,Part3,Document Header3,Part13,Doc
ument Header13,Part22
27
9. Message
9.1 Status Message
Status message, which should be programmed by your dealer only, can facilitate instant messaging of
the frequently-used messages. You can only send or view rather than editing the status messages.
Sending a Status Message
z Press the Function/P1 key or OK key and navigate to “Message -> Create Msg -> StatusMsg -> Sel
Msg”. Select a desired status message, and press the OK key to proceed. Choose either an
individual or a group as the target contact, input the appropriate number and press OK to complete.
z Long press the programmed Send StatusMsg key to send the preset status message directly. When
the message is sent successfully, the receiving terminal will receive the corresponding message text
(if the “status message” is predefined for it) or only the message ID (if the “status message” is not
predefined for it).
Note:
The Send StatusMsg function and the status message are predefined by the dealer via the CPS.
View the Status Message
When the icon appears in the home screen, it indicates there is/are unread message(s). Do as
follows to view it:
z In the prompt screen for an unread message, press the OK key to enter the Inbox, and press OK
again to read.
z In the home screen, press the Function/P1 key or OK key and navigate to “Message -> Inbox ->
Inbox”. Then you can view the unread message.
To Next Page
Loading...
