Hytera PD36X - Device Information; One Touch Call; Time-Out-Timer; Transmission Management

13
LED Indicator
You can set whether to activate the LED indicator. You can set the LED
indication for specic features such as TX, RX, Scan, Low Battery, and
the like.
Tone
You can turn the tone on and off. If it is set to Silent, the radio will give no
tones at all.
Covert Mode
When Covert Mode is enabled, the radio will disable any visible or audible
indications set by your dealer, such as the LED indicator, vibration and
tone. This feature is mainly used in special missions.
If an audio accessory is connected to the radio, it will
output the tone when the Covert Mode is enabled.
Besides the menu, you can also enable or disable this feature by
pressing the programmed Covert Mode key.
Device Information
You can view basic information of the radio, including Radio ID, Radio
Alias, Serial Number, Model Name, Frequency Range, Firmware Version,
Radio Data Version, Boot Loader Version, etc.
Operation: Go to “Settings -> Device Info”.
One Touch Call
This feature allows you to make calls or send messages to the predened
contact easily. By pressing the programmed One Touch Call key, you
can make the following services:
●
To initiate group calls or send messages to the group call contact.
●
To initiate private calls or send messages to the private contact.
Operation
Service Operation
To initiate private calls or group
calls on the digital channel.
Press the programmed One Touch Call
key and then hold down the PTT key.
To send messages.
Press the programmed One Touch Call
key.
Time-Out-Timer
The feature is to prevent you from occupying a channel for an extended
period. If the TX time (60s preset by dealer) expires, the radio will
automatically terminate transmission and keep beeping. To stop beeping,
please release the PTT key. You must wait for a certain time period which
you can congure via the “TOT Re-key Time” menu before you can press
and hold down the PTT key to transmit again.
Transmission Management
This feature can prevent your radio from interfering with other
transmitting radios on the same channel. If you hold down the PTT key
Note
Features and Operations