5
√
× ×
3. Tighten the screw on the connector.
To remove the accessory connector, loosen the screw.
Basic Operations
Powering On/Off
Rotate the Power On-Off/Volume Control knob
clockwise/counter-clockwise until a click is heard to turn
the radio on/off.
Adjusting the Volume
After turning the radio on, rotate the Power On-Off/
Volume Control knob clockwise to increase the output
sound volume, or counter-clockwise to decrease it.
Adjust Power Level
With this feature, you may switch power levels quickly.
Generally, we recommend you to adopt low power for
battery saving. However, if you cannot communicate with
radios located at a distant place with low power, please
select high power.
Operation: Press the programmed Adjust Power Level
key to switch the Tx power of the current channel be-
tween High and Low.
Selecting a Zone
A zone is a group of channels exhibiting the same
property. You can list such channels into a zone for
convenient management to them. This radio supports 3
zones: Zone 1, Zone 2 and Zone 3, each of which can
contain 16 channels at most.
You may quickly toggle to your wanted zone by pressing
the programmed Zone Up or Zone Down key. When
toggling to a zone, you will hear the alert tone for the
zone (one alert tone for Zone 1, two alert tones for Zone
2 and three alert tones for Zone 3).
Selecting a Channel
After turning the radio on, rotate the Channel Selector
knob to select a needed channel. You can also switch
to the designated channel by pressing the programmed
Preset Channel key.
If the Channel Notify function is active, you will hear the
corresponding channel number when switching to any
channel.
Switching the Channel Mode
Each channel can be programmed as either analog
channel or digital channel via your dealer. If the current
zone includes both analog and digital channels, you
may quickly switch between digital and analog channels
through the Channel Selector knob.
Call
To ensure optimal volume of the transmitted voice, keep
the microphone approximately 2.5 to 5 centimeters away
from your mouth.
Private Call
Initiating a Call
In standby mode, hold the PTT key to transmit a private
call to the private call contact preset for the current
channel.
Note: Your dealer may preset a contact for
each digital channel. The preset contact could
be a private call contact, a group call contact
or an all call contact.
Receiving a Call or Calling Back
When a private call is received, you can listen to it
without any operation. You may hold the PTT key within
the preset time period to call back.
Group Call
Initiating a Call
In standby mode, hold the PTT key to transmit a group
call to the group call contact preset for the current
channel.
Receiving a Call or Calling Back
When a group call is received, you can listen to it without
any operation, and you may hold the PTT key within the
preset time period to call back.
All Call
In standby mode, hold the PTT key to transmit an all
call to the all call contact preset for the current channel.
When an all call is received, you can listen to it without
any operation.
To Next Page
Loading...
Need help?
General
