2. Before you Start
2.1 Firmware Version Check
Caution
Please check whether the firmware version of the radio satisfies the requirements before upgrade. If
not, please do not upgrade; otherwise the radio may get damaged.
Step 1 Connect the radio with the PC.
Step 2 Run the CPS to read data from the target radio.
Step 3 Click “Radio Information” on the left of the CPS to check whether the “Firmware Version”
satisfies the requirements specified in the Appendix: Applicable Model and Version.
PD780G is taken as the example.
Step 4 Disconnect the CPS and radio.
Step 5 Turn off the radio.
2.2 Preparations
Please prepare the following items before you start.
PC with operating system Win 7, Win 8, Win 8.1 or Win 10 of 32/64-bit.
Win7 is taken as the example hereinafter.
DMR Upgradekit Subscriber: The upgrade software has been successfully installed on PC.
To Next Page
Loading...
Need help?
General
