5
Radio Overview
Note:
Short Press Key press no longer than 1 second.
Long Press Key press longer than 1 second.
﹡LED Indicator
LED indications and alert tones are shown in the table below (see Advanced
Operations for details):
Status LED Indication and Alert Tone
Power On
1. The power-on alert tone is heard when the radio
is powered on.
2. When the current channel is a blank channel,
beeps are heard.
Radio Standby
The LED flashes blue if no operation is made or
no carrier is present within 2s. You can enable/
disable this LED indication via CPS software and
programming cable.
Low Battery Alert
The LED ashes red and a low pitched tone is heard
every ten seconds.
Transmitting
1. Red LED glows while the radio is transmitting.
2. When transmission times out, continuous beeps
are heard.
3. TOT Pre-alert: one beep is heard.
4.Transmitting PTT ID: continuous beeps
(programmable via CPS software and programming
cable) are heard.
5. Transmitting PTT ID is completed: a short beep
(programmable via CPS software and programming
cable) is heard.
Receiving The LED glows green when carrier presents.
Scanning
1. The LED flashes green every 1 second when
scanning is in process.
2. Scan Start Tone (programmable via CPS software
with programming cable): one beep is heard.
3. Green LED solidly glows when signal is received.
4. Scan Stop Tone (programmable via CPS software
with programming cable): one beep is heard.
Two beeps sound when the feature is disabled.
To Next Page
Loading...
