Hytera TM-610 - Test Cables and Cautions

47
The following test cable is recommended.
Ⅳ
ⅣⅣ
Ⅳ. Cautions When Removing or Attaching the Shield Cover
1. When handling with the shield cover, do not damage the components on the TX-RX
unit.
2. When installing the shield cover, insert the cover from the rear side.
3. When removing the shield cover, squeeze the hole marked with an arrow as shown in
the diagram and pull it straight
This mobile radio can only be tuned via programming software or manually. Manual
Tuning is described as follows. (Refer to ‘Test Mode” and ‘Tuning Mode” in the section
Radio Modes.)
Instrument:
Radio Communication Test Set 1 set
Spectrum Analyzer 1 set
20A/30V Power Supply 1 set
Digital Voltmeter 1 set
Power Meter 1 set
Signal Line (with dummy load) 1 set
Tuning Method and Procedures:
1. Download
 Connect the radio with PC by programming cable; turn the radio on.
1:CM
2:HOOK/RXD
3
.MIC
4:ME
5:PTT/TXD
6:GND
7:PSB
8:MBL
HOOK
MIC
MICG
T0
AG
AF VTVM
PTT
END
CUT
8 PIN