Hytera TM-610 - Tuning Method and Procedures; Initialization; Tuning

48
 Click “Download” on software interface.
 Select the desired program and click “Open”, download starts.
 Click “End” when download is completed.
 Turn the radio off and remove the programming cable.
2. Initialization
It is necessary to set the frequency and initialize the radio before tuning because there is
no needed information in EEPROM when the radio is manufactured.
 Turn on the power while holding down [P2], and press [P4] after LCD displays
“DESTINA+initial value” (Refer to “Initial value/model” in the following table)
 The LED on the front panel finishes flashing, indicating that the initialization is over.
3. Tuning
Some items can be Tuninged in conventional mode and the others in manual tuning
mode.
 Turn on the power to enter conventional mode.
 Switch off the power. And then turn on the power while holding down [P1]. The radio
enter manual tuning mode. The tuning item is displayed on LCD.
 Frequency Table
Model RX/TX 1 ( C ) 2 ( L ) 3 ( H ) 4 5 6 7 8
0 RX(MHz) 155.15 136.15 173.85 145.55 164.50 155.00 155.20 155.40
（ V ） TX(MHz) 155.00 136.00 174.00 145.50 164.50 155.00 155.20 155.40
1 RX(MHz)
435.15 400.15 469.85
417.55
452.50 435.00 435.20 435.40
（ U1 ） TX(MHz)
435.00 400.00 470.00
417.50
452.50 435.00 435.20 435.40
2 RX(MHz)
475.15 450.15 499.85
462.55
487.50 475.00 475.20 475.40
（ U2 ） TX(MHz)
475.00 450.00 500.00
462.50
487.50 475.00 475.20 475.40
3 RX(MHz) 505.15 480.15 529.85 492.55 517.50 505.00 505.20 505.40
（ U3 ） TX(MHz) 505.00 480.00 530.00 492.50 517.50 505.00 505.20 505.40
4 RX(MHz)
375.15 350.15 399.85
362.55
387.50 375.00 375.20 375.40
（ U4 ） TX(MHz)
375.00 350.00 400.00
362.50
387.50 375.00 375.20 375.40
TM-610V：136-174；
TM-610U1：400-470；
TM-610U2：450-500；
TM-610U3：480-530；
TM-610U4：350-400；