4. Basic Operations
4.1 Turning On and Turning Off the Product
Turning On the Product
In power-off mode, press and hold the
On/Off
key for three seconds to turn on the product
.
Turning Off the Product
In power-on mode, press and hold the
On/Off
key for three seconds to turn off the product
.
4.2 Entering BT Pairing
In power-off mode, press and hold the
On/Off
key for five seconds to start BT pairing.
4.3 One-touch Activation and Recording/Photo Taking
In power-off mode, press and hold the
Video Recording
key/
Photo Taking
key to turn on the product
and record video or take photo; press the
Video Recording
key again to exit video recording.
4.4 Recording Videos
In power-on mode, press the
Video Recording
key to record video; press the key again to exit video
recording.
The product supports loop recording. In loop mode, when the TF card is full and a new
video is being recorded, the product automatically deletes the oldest video by date. You
can program this feature through the RVM Manager.
If the post-event recording feature is enabled, the product automatically enters
post-event recording mode after the recording is deactivated
.
4.5 Pre- and Post-event Recording
The RVM is capable of pre- and post-event recording to ensure all interactions during an incident are
captured. Pre-event recording allows officers to capture a period time of footage prior to an event that
led them to press the record button, while post-event recording can add a period time of footage after
To Next Page
Loading...
