5-9
1. OPERATIONAL CHECKS
This procedure is designed so the service man can make a quick check of the steering system using
a minimum amount of diagnostic equipment. If you need additional information, refer to structure and
function in group 1.
A location will be required which is level and has adequate space to complete the checks.
The engine and all other major components must be at operating temperature for some checks.
Locate system check in the left column and read completely, following this sequence from left to right.
Read each check completely before performing.
At the end of each check, if no problem is found(OK), that check is complete or an additional check is
needed. If problem is indicated(NOT OK), you will be give repair required and group location. If
verification is needed, you will be give next best source of information :
·
Chapter 2 : Troubleshooting
·
Group 3 : Tests and adjustments
G
GROUP 2 OPERATIONAL CHECKS AND TROUBLESHOOTING
To Next Page
Loading...
Need help?
General
