What to do if Hyundai Forklifts truck cannot start?
If your Hyundai Forklifts won't start, the storage battery might be depleted; inspect, charge, or replace it. Check for a loosened wire terminal and screw down the terminal screw. Also, the fuse could be burnt out, so replace the fuse. If the accelerator is damaged, replace accelerator.
How to fix abnormal noise during lifting Hyundai Forklifts?
If you notice abnormal noise during lifting with your Hyundai Forklifts, it could be due to several reasons. The oil-absorptive filter might be blocked, requiring cleaning or replacement. Alternatively, there could be a leak in the oil-absorptive tube, leading to oil foaming; in this case, try fastening the tie-in, checking the oil level, and adding more oil if needed. Also, the viscidity of oil might be incorrect, or the oil level is too low, so consider replacing the oil or adding some. For hydraulic pump/motor damage or seal malfunction causing air to enter the oil pump, it's best to contact maintenance personnel.
What to do if hydraulic system has no pressure in Hyundai Forklifts?
If the hydraulic system of your Hyundai Forklifts has no pressure or the pressure is too low, several factors could be responsible. There may be a malfunction in pump oil-absorptive, accompanied by noise, which can be resolved by replacing the oil or adding some. The pipeline might be broken or leaking, so replace the pipeline or screw down the tie-in. Also, the oil's viscosity might be unsuitable, leading to excessive leakage; in that case, change the oil. For issues like a damaged oil pump or a malfunction in the valve block, it's recommended to contact maintenance personnel.
Why is the oil pressure not stable in Hyundai 20EPR Forklifts?
If the oil pressure in your Hyundai Forklifts is unstable, it could stem from issues causing abnormal noise, so refer to the treatment methods for abnormal noise. Also, the lifting cylinder or seal ring might be worn, requiring replacement of the cylinder sleeve or seal ring. Ensure that the oil quantity is sufficient by adding more oil.
Why is the direction ineffective and heavy in Hyundai 20EPR?
If the direction of your Hyundai Forklifts is ineffective and heavy, the steering device might be blocked by a foreign matter; clean up the foreign matter. Also, the bearings of the steering device might be worn, so replace the bearings.
What to do if Hyundai Forklifts not release after braked?
If your Hyundai Forklifts doesn't release after being braked, the electromagnetic brake may be out of electricity, so check the circuit. Alternatively, the clearance of the electromagnetic brake might be too large; adjust the brake clearance to 0.2mm.
General| Model | 20EPR |
|---|---|
| Type | Electric Forklift |
| Battery Voltage | 48 V |
| Load Capacity | 2000 kg |
| Load Center Distance | 500 mm |
| Wheel Type | Solid |
| Overall Width | 1150 mm |
To Next Page
