Remove the center console box.
Remove Air-bag SRSCM connector.
Connect disposal tool to the air bag checker R-terminal.
Connect SRS air bag adapter harness battery (+) and (-) when the SRS harness checker still disconnected, to prevent
sudden unexpected deployment of the air bag.
Connect the SRS harness checker to SRSCM harness side connector.
At location as far away from the vehicle as possible, press the push button (removed from the vehicle) to deploy the
air bag.
DEPLOYED AIR BAG MODULE DISPOSAL PROCEDURES
After deployment, the air bag module should be disposed of in the same manner as any other scrap parts, except that
the following points should be carefully noted during disposal.
CAUTION
1.
Before deploying the air bag in this manner, first check to be sure that there is no
one in or near the vehicle. Wear safety glasses.
2.
The inflator will be quite hot immediately following the deployment, so wait at
least 30 minutes to allow it to cool before attempting to handle it. Although not
poisonous, do not inhale gas from air bag deployment. See Deployed Air Bag
Module Disposal Procedures for post-deployment handling instructions.
3.
If the air bag fails to deploy when the procedures above are followed, do not go
near the module.
To Next Page
Loading...
Need help?
General
