6
DO-IT-YOURSELF MAINTENANCE
8
!
HGK5005
G030D01A-GAT
Adding Oil
1.6L/2.0L
G350A01A-GAT
Engine Oil Consumption
Function of Engine Oil
Engine oil has the primary function of
lubricating and cooling the inside of
the engine.
Engine oil consumption
It is normal that an engine should
consume some engine oil while nor-
mal driving. The cause of oil con-
sumption in a normal engine are as
follows;
o Engine oil is used to lubricate pis-
tons, piston rings and cylinders.
A thin film of oil is left on the
cylinder wall when a piston moves
downwards in the cylinder. High
negative pressure generated dur-
ing engine operation sucks some
of the oil into the combustion cham-
ber.
This oil with some oil of the cylin-
der wall is burned by the high tem-
perature combustion gases during
the combustion process.
2.7L
If the oil level is close to or below the
"L" mark, add oil until it reaches the
"F" mark. To add oil:
1. Remove the oil filler cap by turning
it counter-clockwise.
2. Add oil, then check the level again.
Do not overfill.
3. Replace the cap by turning it clock-
wise.
The distance between the "F" and "L"
marks is equal to about 1 liter of oil.
WARNING:
Be very careful not to touch the
radiator hose when adding the en-
gine oil as it may be hot enough to
burn you.
To Next Page
Loading...
Need help?
General
