1
FEATURES OF YOUR HYUNDAI
24
B180A03Y-GAT
SEAT BELTS
Driver's and passenger's 3-Point
System with Webbing Clamp
Locking Retractor (If installed)
To Fasten Your Belt
To fasten your seat belt, pull it out of the
retractor and insert the metal tab into
the buckle. There will be an audible
"click" when the tab locks into the
buckle.
The seat belt automatically adjusts to
the proper length only after the lap belt
is adjusted manually so that it fits
snugly around your hips. If you lean
forward in a slow, easy motion, the belt
will extend and let you move around.
B180A02A-GAT
SEAT BELTS
3-Point System with Emergency
Locking Retractor (If installed)
To Fasten Your Belt
B180A01L
B180A01L
If there is a sudden stop or impact,
however, the belt will lock into position.
It will also lock if you try to lean forward
too quickly. Check to make sure that
the belt is properly locked and that the
belt is not twisted.
!
To adjust the height of the seat belt
anchor, lower or raise the height ad-
juster into an appropriate position. To
raise the height adjuster, pull it up. To
lower it, push it down while pressing
the height adjuster button.
Release the button to lock the anchor
into position. Try sliding the height
adjuster to make sure that it has locked
into position.
WARNING:
o The height adjuster must be in
the locked position when the
vehicle is moving.
o The misadjustment of height of
the shoulder belt could reduce
the effectiveness of the seat belt
in a crash.
To fasten your seat belt, pull it out of the
retractor and insert the metal tab into
the buckle. There will be an audible
"click" when the tab locks into the
buckle.
To Next Page
Loading...
