Hyundai MIG-200 - User Manual

Questions and Answers

H
Hayden CookJul 26, 2025
Why is the overheating LED on in my Hyundai MIG-200?
- J
  Jamie RoseJul 26, 2025
  The overheating LED might be on due to several reasons. First, verify the welding current and welding time, ensuring they align with the duty cycle requirements as detailed in the manual. Next, check if the fan is running during welding. If the fan isn't working, check its power supply (230V). If the power supply is normal, inspect the fan itself; if abnormal, check the power supply's connecting cable. Finally, the thermal switch might be damaged and need replacement.
M
Marie BeltranAug 2, 2025
How to fix unstable welding current in Hyundai MIG-200?
- V
  Victoria HortonAug 2, 2025
  Unstable welding current can stem from several factors. Ensure the pressure arm on the wire feeder has proper pressure. Also, confirm that the drive roll matches the wire size you're using. Inspect the contact tip of the welding torch for wear; replace and tighten if needed. Check the welding wire to make sure it is good quality. See if the torch cable is too twisted. Finally, verify that the quick plug is not loose.
M
Mary MendozaAug 9, 2025
What to do if the power LED is off and there is no output current in my Hyundai MIG-200?
- M
  Matthew LopezAug 9, 2025
  If the power LED is off and there's no output current, first check if the fan is working. If the fan isn't working, this suggests that the power cord is not making good contact. However, if the fan is working, it indicates a failure of the control PCB inside the machine.
N
Nicholas BennettAug 16, 2025
What to do if there is no response when pushing the torch trigger on Hyundai MIG-200?
- J
  John RiosAug 16, 2025
  If there's no response when you push the torch trigger and the protection LED is off, first check if the gun trigger is making good contact. Next, ensure the welding torch is properly connected to the European connector, and check the control jack of the European connector. If these checks pass, the control PCB inside the machine may be faulty.