i-box Dawn - Clock Setting; Alarm Setting Procedure; Alarm Enable and Disable; Stopping and Snoozing Alarms

07 | Dawn
Clock setting
1. Plug in the DC 5V adaptor, the unit will display the default time 0:00.
2. Press and hold
(7) for 1-2 seconds, the display will then show 24hr.
3. Press
(2) or (4) to switch between 24hr and 12hr time.
4. Press
(7) again to set the hour.
5. Press
(2) or (4) to change the hour.
6. Press
(7) to set the minute(s.
7. Press
(2) or (4) to change the minute(s).
8. Press
(7) to finish once the time has been set.
Alarm setting
1. In standby mode (or clock mode), press and hold (6) for 3 seconds, the unit will
then allow you to set the first alarm.
2. Press
(2) or (4) to select the AL1 hour.
3. Press
(6) and / (2/4) to select the AL1 minute(s).
4. Press
(6) and / (2/4) again to select the AL1 source (beep or FM).
5. Press
(6) and / (2/4) to select the AL2 hour.
6. Press
(6) and / (2/4) to select the AL2 minute(s).
7. Press
(6) and / (2/4) again to select the AL2 source (beep or FM).
8. Press
(6) again once the alarm(s) has been set to exit.
Alarm enable/disable
1. In standby mode, press (6) to enable the alarm.
2. The alarm will cycle through: AL1 / AL2 / AL1 and AL2 / off.
Stop & Snooze alarm
When the alarm sounds, press (5, Snooze)
to delay the alarm for 9 minutes.
Press
(8) to turn off the alarm.
Dimmer
Press (5, Snooze) to select the brightness of the display.
Alarm volume
Vol: 0-7 40s
+
6:25