To Next PageTo Next PageWhat to do if the i-SENS Blood Glucose Meter display is blank?
If the display of your i-SENS Blood Glucose Meter is blank after inserting a test strip, consider the following: Ensure the test strip is inserted with the contact bars facing up and is fully inserted into the test strip port. Verify that you are using the correct test strip. Also, check that the batteries are correctly inserted with the + side facing up, and try replacing the batteries.
What to do if test result doesn't match how I feel with i-SENS CARESENS DUAL Blood Glucose Meter?
If the test result from your i-SENS Blood Glucose Meter doesn't match how you feel, repeat the test with a new test strip. Also, check the expiration or discard date of the test strip and perform a control solution test.
What to do if the display is blank on my i-SENS CARESENS DUAL?
If the display of your i-SENS Blood Glucose Meter is blank after inserting a test strip: - Check that the test strip is inserted with the contact bars facing up. - Ensure the strip is fully inserted into the test strip port. - Verify you're using the correct test strip. - Check that the batteries are inserted correctly, with the + side facing up. - Try replacing the batteries.
What to do if test doesn't start after applying blood on i-SENS CARESENS DUAL?
If the test on your i-SENS Blood Glucose Meter doesn't start after applying the blood sample, ensure the confirmation window is completely filled. If not, repeat the test using a new test strip.
What to do if wrong test strip is used with i-SENS Blood Glucose Meter?
If you receive an error message on your i-SENS Blood Glucose Meter indicating the wrong test strip was used, repeat the test with a CareSens PRO or KetoSens test strip.
What to do if i-SENS CARESENS DUAL test doesn't start?
If your i-SENS Blood Glucose Meter test does not start after applying the blood sample, check if the confirmation window is completely filled. If not, repeat the test using a new test strip.
General| Measurement Range | 20-600 mg/dL |
|---|---|
| Sample Type | Capillary whole blood |
| Test Time | 5 seconds |
| Memory Capacity | 1, 000 test results |
| Display | LCD |
| Operating Temperature | 10 - 40 °C (50 - 104 °F) |
| Operating Humidity | 10-90% RH |
| Result Calibration | Plasma-equivalent |
| Wireless Communication | Bluetooth |
| Sample Size | 0.5 μL |
| Battery Type | CR2032 |
| Battery Life | Approximately 1000 tests |
