EasyManua.ls Logo

I-Tech MAG700 - CARRIAGE AND STORAGE; Carriage Precautions; Storage Precautions; Disposal

I-Tech MAG700
32 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
IACER Srl 21 MNPG69-09
ATTENTION! Always respect the polarity of the applicators paying
attention to insert the bobbins with the side indicated by the + symbol
turned to the green part of the elastic belt (therapeutic side).
When not using the device for a long time, clean the device and its accessories
as mentioned before. Place the device and the accessories in the carriage bag
and store them in their box.
When using the same applicator (belt with 2 solenoids) in different patients,
we recommend cleaning it as mentioned before.
Pay attention to respect the temperature, humidity and pressure limits
mentioned in this manual also during the cleaning of the device and its
accessories.
CARRIAGE AND STORAGE
Carriage precautions
MAG700 is a portable device, so it does not need any particular carriage
precautions. However, we recommend putting away MAG700 and its
accessories in their own bag after every treatment, and store everything
inside the packaging box.
The environmental conditions allowed are the same as per following.
We recommend not to roll up the power supply and the applicators cables.
Storage precautions
The equipment is protected upon the following environmental conditions:
Outside the carrying bag:
temperature from +5 to + 40 °C
relative humidity from 10 to 93%
atmospheric pressure from 700 to 1060hPa
Inside the supplied carrying bag (even for transport):
temperature from 5 to +40 °C
relative humidity from 10 to 93%
atmospheric pressure from 700 to 1060hPa
Disposal
The MAG700 magnetotherapy apparatus, compatibly with the operating
and safety requirements, has been designed and built to have a minimum
negative impact on the environment, following the provisions of the
European Directive 2012/19/EU on the disposal of waste electrical and
electronic equipment.
The criteria followed are those of minimizing the amount of waste, toxic
materials, noise, unwanted radiation and energy consumption.

Related product manuals