I-Tech Power Q-6000 Plus

To Next Page

To Previous Page

IACER SRL Page 16 di 22 MNPG80-01 of 06/05/2016

There is no

pressure or the

air doesn’t go

into the

chambers

 Check the applicators right

connection to the main body

 Check if the tubes are pressed or

bent

 Check if the compression chambers

swell up in a progressive way

Air goes into the

compression

chambers and/or

an air leakage is

present in the

applicators

 Check if there are any holes or

damages in the compression

chambers. If there are not any air

leakages, switch off the device then

switch on it and re-check the right

working

Warnings

The following warnings guarantee user safety and prevention

against damages and/or lesions.

Please read it carefully before using Power Q-6000 Plus.

I-Tech Power Q-6000 Plus - Warnings