I-Tech UT2 - Page 35

IACER Srl 35 MNPG117-02
Recommended separation distances between portable and mobile radio
equipment for I-TECH U1 not sustaining vital functions
I-TECH UT2 is intended for use in an electromagnetic environment in which radiated
RF disturbances are controlled. The customer or the user of I-TECH UT2
can help
prevent electromagnetic interference by maintaining a minimum distance between
portable and mobile RF communications equipment (transmitters) and I-TECH UT2 as
recommended below, according to the maximum output power of the
communications equipment.
Rated maximum
output power of
transmitter
(W)
Separation distance according to the frequency of the
transmitter (m)
 150
 800 
 80
 800 
 800
 2,7
0.01
0.12
0.12
0.23
0.1
0.37
0.37
0.74
1
1.17
1.17
2.33
10
3.69
3.69
7.38
100
11.67
11.67
23.33
For transmitters rated at a maximum output power not listed above, the recommended
separation distance d in metres (m) can be determined using the equation applicable to the
frequency of the transmitter, where P is the maximum output power rating of the transmitter in
watts (W) according to the transmitter manufacturer.
Note
(1) At 80MHz and 800MHz, the separation distance for the higher frequency range applies.
(2) These guidelines may not apply in all situations. Electromagnetic propagation is affected
by absorption and reflection from structures, objects and people.
I-TECH UT2. All rights reserved I-TECH UT2 and the logo are property
exclusively of I.A.C.E.R. Srl and registered.
Edition: MNPG117-02 of the August 10
th
, 2020