IBC TopFix 200 - Page 24

24
Version 17.01, as of: 27-Jun-2017
4.3.10 “Alu-Mammut SV+” roof hooks
For vertical installation of the carrier profile in the 1st layer.
parameters
value
Material
Alumnium EN AC-42100 (nach DIN EN 1706)
yield strength
hook: f
y,k
= 210 N/mm²
Dimensions base plate (length /
width / height)
181/ 71/ (12) mm
Dimensions hook (width / height)
40/ 6-8 mm und 35/ 6-8 mm
Drilling holes baseplate
∅ 9 mm
Drilling holes hook
slot ∅ 9 mm, L=25 mm
Hook distance from the base plate
46 mm
weight
0,500 kg
General construction approval
Z-14.4.-515
Maximum ch. load / roof hook [kN]
pressure F
R,k,-x
= 2,85
suction F
R,k,+x
= 1,90
shear F
R,k,y
= 2,20
Accessories
flat head screw 6x100-A2 TX25
flat head screw 8x100-A2 TX40
flat head screw 8x140-A2 TX40
flat head screw ASD 8x240-A2 TX40
countersunk screw 8x280 TX40
flat head screw ASD 8x300-A2 TX40
countersunk screw 8x340 TX40
connection piece for roof hook profile M10
Figure 31: parameters roof hook “Alu-Mammut SV+”
Figure 30: “Alu-Mammut SV+” roof hook