IBC TopFix 200 User Manual

50
Version 17.01, as of: 27-Jun-2017
05. Fitting carrier rails
 Insert the pre-assembled securing screw (M10 connection piece for roof hook profile) through the
roof hook slot. Rotate by 90° and insert into the mounting groove of the e.g. TF50+ carrier rail.
Connect TF50+ carrier rail to the roof hooks at the required height and tighten the screw.
Important: Please ensure all teeth of the type e.g. TF50+ carrier rail have engaged in the recess!
 Start with the top or the bottom carrier rail. Align the screws with the fixing points (e.g. roof hooks)
and secure them. See Figure 87.
 If required, extend the carrier profiles using butt connectors. Butt connectors enable ideal alignment
of the carrier rails.
 Do no exceed a maximum carrier rail length of 3 rods (approximately 15,60 m) for continuous carrier
rails due to thermal expansion.
 Prevent any water from collecting in the carrier rails to prevent frost damage.
Figure 89: Fitting carrier rails
Figure 87: Carrier rail, fitted
Figure 88: Mounting carrier rails

IBC TopFix 200 Specifications

General

Brand	IBC
Model	TopFix 200
Category	Racks & Stands
Language	English