To Next Page

To Previous Page

Version 17.01, as of: 27-Jun-2017

07. Fitting cable clips

The cable clips are used to fix the module connector cables and prevent sagging of the cable. The clips

can be clamped to the carrier rails of the mounting system TopFix 200 or to the photovoltaic module

frames without any tools. Figure 96 shows the attachment of the cable clips 0° at the PV-module frame. In

Figure 97 the cable clip is shown schematically 90° on a support profile.

Figure 96: cable clip 0° on module frame

Figure 97: cable clip 90° on support profile

Questions and Answers:

Need help?

Do you have a question about the IBC TopFix 200 and is the answer not in the manual?

IBC TopFix 200 Specifications

General