27
Version 17.01, as of: 27-Jun-2017
4.5 "Mammut Form S+" roof hook
The same conditions and prerequisites as described in section 4.1 apply. "Mammut Form S+" roof hooks
are suitable for 30×50mm and 40×60 mm battens.
For available types and colours of tiles, please refer to the IBC Premium Partner portal. Your personal IBC
SOLAR AG contact person will of course also be happy to help.
Note:
Superficial damage to the surfaces (scratches) that affect neither static, nor anti-corrosion properties of the
roof hook shall not be accepted as a valid reason for complaints.
IBC SOLAR AG recommends to test one "Mammut Form S+" on the available roof tiles as there may be
manufacturer-specific dimensions despite the designations being identical (e.g. Tegalit prior to 1996).
4.5.1 Fitting "Mammut Form S+" roof hooks
Step 1:
Figure 37: "Mammut Form S+" roof hook
Specify the roof hook position so that you do not exceed a distance of 150 mm between fastener
element (1) and the centre of the rafter.
Legend:
(1) Hook
(2) Reinforcing runner
(3) Support member
(4) 4.2×32 mm drilling screw
(5) 5.0×120 mm drilling screw
(6) 5.0×60 mm drilling screw
To Next Page
Loading...