34
Flash (BIOS/VPD) update procedure
1. Power-off the computer.
2.
Insert the flash update diskette into drive A.
3. Power-on the computer.
4. When the Update Utility appears; select the country/keyboard, and then press Enter.
5. If the computer serial number was previously recorded, the number is displayed with an option to update it. Press Y to update the serial
number.
6. Type the 7-digit serial number of the computer you are servicing, then press Enter.
7. Follow the instructions on the screen to complete the flash (BIOS/VPD) update procedure.
Attention: Refer to the information label located inside the system unit cover for any model-specific information.
To Next Page
Loading...
Need help?
General