IBM 3852-2 User Manual

5.
Did you
perform
ink supply pumping
when
you
turned the
printer
On?
Print
Verification
NO -- Continue with
this
step.
Perform
the
ink
supply
pumping
and print
verification.
Perform the
ink pumping
operation
using the
procedure
explained
in “Ink
Supply Pumping” on
page 3-30.
Remember
you will need to
do
the print
verification
operation after
you
have
completed
the pumping
operation.
That
procedure
is
explained
in “Print
Verification” on
page 3-27. Try to
print
the Self
Test
again.
If
this doesn’t correct
the problem,
go
to Step 6.
YES-- Go to
Step
6.
6.
Did you
perform
the
ink supply
pumping a
number
of times (three
to
six times)?
NO -- Continue
with this
step.
Repeat
the
ink supply pumping
operation
several
times. Perform the
ink
pumping
operation
using the
procedure
explained
in “Ink Supply
Pumping” on page
3-30.
Remember
you will need to do
the
print
verification
operation
after
you have
completed
the
pumping operation.
That
procedure
is explained
in “Print
Verification” on
page 3-27. Try to
print
the Self
Test
again.
If this still
doesn’t
correct the
problem
go to Step 7
on
page 4-5.
After unlocking
the
carriage,
you
should
perform
print verification
to make sure the
ink-jet
printing system is
working
correctly.
You
normally have to
do
this when you set
up
your
printer.
You
will
also want to
verify
printing
if
you
replace
ink
cartridges
or move
the machine.
You
can
only
do
print verification
after
unlocking
the carriage or
after
ink supply
pumping.
Make
sure
the blue
lever is
in the
“normal” position.
Remember
Position
3
is the
normal
position.
Follow these instructions.
1.
Press the Line
Feed switch, and
the printer
will start printing
the
verification pattern
shown below.
Print
Verification
Pattern
.—
.
2.
If the print verification
pattern is not
printed
correctly, repeat the
procedure
explained in
“Ink Supply Pumping”
on page 3-30.
YES -- Go
to Step
7
on page 4-5.
A A
flyiivi+hii, -97

IBM 3852-2 Specifications

General

Brand	IBM
Model	3852-2
Category	Printer
Language	English