EasyManuals Logo

IBM 412 - 412 Corded Phone User Manual

IBM 412 - 412 Corded Phone
36 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #17 background imageLoading...
Page #17 background image
17
LIST OF SYSTEM DEFAULTS
The default telephone setup is as follows:
You may clear all programmed data and all the parameters will revert to the above default values. To
do this:
1. Press [STORE].
2. Press [*], [#], [*], [#].
3. Press [MUTE].
4. A short ring will be heard to signal successful programming.
ASSIGNING EXTENSION NUMBERS (11 THROUGH 22)
When you use two or more telephones, each telephone must be assigned a different extension num-
ber. If two stations are given the same number, you will hear a loud continuous warning alerting you to
the system error.
All phones arrive with the default extension number 11. Valid extension numbers are 11 through 22.
To program extension numbers, follow these steps, assigning numbers sequentially to each extension:
1. Press [STORE].
2. Press [1], [0].
3. Enter 2 digits XX where XX is a number from 11 to 22.
4. Press [MUTE].
5. A short ring will be heard to signal successful programming.
TELEPHONE OPERATIONS SETUP
Function Default
Tone/Pulse Mode Tone
Headset Disable
Extension Number 11
Ringer On 4 lines
Line Connection On 4 lines
Speaker Volume 12th level
Handset Volume Minimum level
Headset Volume Middle level
Ringer Volume Middle level
Speed Dial Empty
Area Code Empty

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the IBM 412 - 412 Corded Phone and is the answer not in the manual?

IBM 412 - 412 Corded Phone Specifications

General IconGeneral
BrandIBM
Model412 - 412 Corded Phone
CategoryTelephone
LanguageEnglish