EasyManuals Logo

IBM 412 - 412 Corded Phone User Manual

IBM 412 - 412 Corded Phone
36 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #21 background imageLoading...
Page #21 background image
21
USING AUTO REDIAL
If the phone number dialed is busy or not answered, the phone can automatically redial the number
approximately every 60 seconds up to 10 times.
1. Press an available [LINE] key [LINE1, LINE2, LINE3, or LINE4]
2. Press [REDIAL]. The [REDIAL] LED will flash and the [MUTE] key will be lit, indicating the phone
is in Auto Redial mode. No further action is required.
To cancel Auto Redial:
1. Press [REDIAL] and hang up the phone.
ANSWERING AN INCOMING CALL
Using the Handset
1. Lift the handset. You will automatically be connected to the ringing outside line.
Using the Speakerphone (hands free)
1. Press the [LINE] key with the flashing LED to be connected with the outside call or simply press
the speakerphone [SPKR] key to be automatically connected to the ringing outside line.
2. Press the [SPKR] key again to end the call.
PLACING A CALL ON HOLD
Placing a Call on Hold
1. Press the [HOLD] key to put the current line on hold. The line LED will flash rapidly.
Releasing a Call on Hold
1. To release a call on hold, press the [LINE] key of the call that is on hold.
NOTE: You can access the line (call) on hold from any extension.

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the IBM 412 - 412 Corded Phone and is the answer not in the manual?

IBM 412 - 412 Corded Phone Specifications

General IconGeneral
BrandIBM
Model412 - 412 Corded Phone
CategoryTelephone
LanguageEnglish