18
NOTE: The programmable speed dial keys double in function as Direct, Station to Station (DSS) keys. The
uppermost left key is extension (Station) 11, the next key to the right is extension 12, etc. When
using the features intercom (ICM) and page, extensions may be dialed by pressing these keys even
after each key has also been programmed as a speed dial number.
PROGRAMMING TONE OR PULSE MODE
Tone mode is the system default. To change the setting to either pulse or tone:
1. Press [STORE].
2. Press [0], [0].
3. Press [0], [1] for TONE mode, or [0], [0] key for PULSE mode.
4. Press [MUTE].
5. A short ring will be heard to signal successful programming.
PROGRAMMING LINE CONNECTION ON/OFF
This refers to deactivating individual phone lines on an extension. By default, all lines are ON.
To deactivate a phone line(s) for an extension, program that extension to turn OFF the phone line con-
nection for that specific line (L1, L2, L3, or L4). If a phone does not have 4 incoming phone lines, those
lines that are not used will appear lit (the LED on the [LINE] keys will be lit) unless the line connection
is programmed OFF. To set:
1. Press [STORE].
2. Press [5].
3. Press a digit X where X is for line numbers 1-4.
4. Press [0], [1] for ON, or [0], [0] for OFF.
5. Press [MUTE].
6. A short ring will be heard to signal successful programming.
PROGRAMMING RINGER ON/OFF
The ringer may be turned OFF and ON for incoming calls on a line-by-line basis. To set the ringer value
for an individual phone line:
1. Press [STORE].
2. Press [2].
3. Press a digit X where X is for lines 1-4.
To Next Page
Loading...
General