VendorName "Intel"
Option "NoAccel" "yes"
[...]
EndSection
2) Uninstall all Compiz packages (refer to the SLED 11 documentation).
b. To use the FBdev video driver:
1) Open the /etc/X11/xorg.conf file in a text editor and modify the Driver line in the "Device"
section as follows:
Driver "fbdev"
2) Perform the procedures in “FBdev driver configuration” on page 6.
4. (4800-721 only) Uninstall all Compiz packages (refer to the SLED 11 documentation).
5. Perform the procedures in “Serial touch screen calibration” on page 3.
IBM SurePOS 700 4800-7x2
To fully configure SLED 11 to run on an IBM SurePOS 700 4800-7x2:
1. Install SLED 11 according to the documentation at http://www.novell.com/documentation/sled11/
index.html.
2. (4800-722 only) Configure the display:
a. Launch the terminal application from Init 3 text console mode.
b. To use the Intel video driver:
1) Open the /etc/X11/xorg.conf file in a text editor and modify the "Device" section to add (or
change) the following lines:
Section "Device"
Driver "intel"
Identifier "Device[0]"
Screen 0
VendorName "Intel"
Option "NoAccel" "yes"
[...]
EndSection
2) Uninstall all Compiz packages (refer to the SLED 11 documentation).
c. To use the FBdev video driver:
1) Open the /etc/X11/xorg.conf file in a text editor and modify the Driver line in the "Device"
section as follows:
Driver "fbdev"
2) Perform the procedures in “FBdev driver configuration” on page 6.
3. Perform the procedures in “Serial touch screen calibration” on page 3.
IBM SurePOS 700 4800-7x3
To fully configure SLED 11 to run on an IBM SurePOS 700 4800-7x3:
1. Install SLED 11 according to the documentation at http://www.novell.com/documentation/sled11/
index.html.
2. Perform the procedures in “VIA display driver installation and configuration” on page 6.
3. Perform the procedures in “Serial touch screen calibration” on page 3.
14 Linux OS Configuration
To Next Page
Loading...
